From: Michel Gaspard (mgaspard@xxxxxxxxx)
Date: Thu Apr 12 2001 - 10:05:46 GMT-3
Lin,
What do you mean exaclty with "ping from one spoke router to another's ehternet
IP"
Do you mean IPX pings, or IP pings?
The fact that IPX routing is OK has no influence on the IP routing, unfortunate
ly...
Otherwise (IPX pinmgs), could you send your config?
Try also to map the other spoke router's IPX address to DLCi on the interfaces.
Check the IPX routing table for these destinations.
Regards,
Michel
> From nobody@groupstudy.com Thu Apr 12 14:52:13 2001
> From: "Haohong Lin" <hhlin@szskzj.com>
> To: "CCIELab" <ccielab@groupstudy.com>
> Subject: IPX over Frame Relay
> Date: Thu, 12 Apr 2001 20:50:33 +0800
> Sender: nobody@groupstudy.com
> Reply-To: "Haohong Lin" <hhlin@szskzj.com>
>
> Hi,
>
> When I using EIGRP as IPX routing protocol on Frame Relay network, every
> ipx routes seemed fine after disabled IPX split-horizon on hub router. But I
> tried to ping from one spoke router to another's ehternet IP, packets
> stoped on hub router's serial interface. How can I resolve this problem?
>
>
> Haohong Lin
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:44 GMT-3