From: McCoy, Jeffery (jmccoy@xxxxxxxxxxxxxxxxx)
Date: Fri Apr 06 2001 - 19:13:52 GMT-3
what about with snapshot routing. I have snapshot routing configured and
working fine across 1 channel. A requirement says that if util reaches 20%
enable the second channel. I have done this with these commands:
ppp multilink
dialer load 52 either
problem: now snapshot routing doesnt occur over the isdn link. Upon a
debug of IPX packet
I get the following error:
IPX: local:6005.0010.7be7.c64c->6005.ffff.ffff.ffff ln= 64 tc=00, encap
failed
any ideas?
-----Original Message-----
From: Kevin M. Turek
To: Tariq Sharif; Ccielab@Groupstudy. Com
Sent: 4/6/2001 3:58 PM
Subject: Re: ISDN & Multilink
No. The ppp multilink command allows your b-channels to be "bonded".
The
dialer-load threshold command specifies at what time to bring up the
second/multiple b-channels. Dialer-load threshold 1 either says to
bring up
the second channel when the link is loaded with a value of 1(seen with
show
int), essentially, when any traffic is present on the link. The either
keyword specifies the traffic can be either inbound or outbound. Also,
if
your traffic falls below the specified load, it will disconnect the
additional call that has been made.
HTH,
Kevin
----- Original Message -----
From: "Tariq Sharif" <tariq_sharif@btinternet.com>
To: "Ccielab@Groupstudy. Com" <ccielab@groupstudy.com>
Sent: Friday, April 06, 2001 3:30 PM
Subject: ISDN & Multilink
> Quick one, do you need "dialer load threshold" command for ppp
mutilink to
> work? My ISDN switch does not support it so can't test it. I see some
> configs as just "ppp mutilink" others have "dialer load-threshold 1
either"
> and " ppp multilink"
>
> Many thanks & regards.
>
> Tariq Sharif
>
> [GroupStudy.com removed an attachment of type application/ms-tnef
which
had a name of winmail.dat]
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:42 GMT-3