From: Clifton Stewart (cliftonlstewart@xxxxxxxx)
Date: Thu Apr 05 2001 - 17:29:46 GMT-3
Markus,
This problem has surfaced before, usually a good place to search is the
archives. You have a mapping issue, see the below url.
http://www.cisco.com/warp/public/116/fr_faq.html#1
-Cliff
Markus Haas wrote:
> Hi,
>
> I want to ping my own Interface adress with Frame-Relay encapsulation.
> But it doesn't work. Here's the interface config:
>
> R3#sh run int ser 0
> Building configuration...
>
> Current configuration:
> !
> interface Serial0
> bandwidth 1984
> ip address 10.1.10.2 255.255.255.252
> no ip directed-broadcast
> encapsulation frame-relay
> no keepalive
> frame-relay interface-dlci 100
> end
>
> R3#ping 10.1.10.2
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 10.1.10.2, timeout is 2 seconds:
> .....
> Success rate is 0 percent (0/5)
> R3#
> R3#ping 10.1.10.1
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 10.1.10.1, timeout is 2 seconds:
> !!!!!
> Success rate is 100 percent (5/5), round-trip min/avg/max = 4/5/8 ms
> R3#sh frame
> R3#sh frame-relay map
> R3#sh frame-relay map
> Serial0 (up): ip 10.1.10.1 dlci 100(0x64,0x1840), dynamic,
> broadcast,
>
> Maybe it works with a trick.
> Have somebody a soutlion for me ?
>
> Markus
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:41 GMT-3