From: Erick B. (erickbe@xxxxxxxxx)
Date: Wed Apr 04 2001 - 03:58:49 GMT-3
That may work. Also just a FYI, sometimes removing a
sub-interface, DLCI/PVC assignment doesn't completely
remove it from the routers memory until a reboot.
Thats why it complains about being in use already.
This behavior may change depending on what you
configure/remove and may vary in IOS versions.
My suggestion is to do a write-mem and reload if
you've been making lots of config changes, etc so you
have less chance of some process getting stuck in
memory somewhere preventing things from running
correctly.
--- Chuck Larrieu <chuck@cl.cncdsl.com> wrote:
> Try a clear fram map
>
> Yes I have seen the issue before and I believe this
> did it - that I did not
> have to resort to a reload
>
> HTH
>
> Chuck
>
> -----Original Message-----
> From: nobody@groupstudy.com
> [mailto:nobody@groupstudy.com] On Behalf Of
> Steven Weber
> Sent: Tuesday, April 03, 2001 7:01 PM
> To: GROUPSTUDY
> Subject: fram interface-dlci xxx
>
> Has anyone accidentally applied the wrong dlci to an
> interface with the
> frame-rela interface-dlci command and try to delete
> it? It goes away when I
> do
> a sh run but whe I try applying it to a different
> interface it comes up as
> already being used. I'm running IOS v12.0 5. How do
> I remove the dlci from
> the
> interface so I can apply to a different interface.
> Thanks,
> Steve
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:40 GMT-3