From: fabricio (fabricio@xxxxxxxxxxxx)
Date: Wed Feb 28 2001 - 13:36:24 GMT-3
Your right, split horizon will not affect OSPF, but it will affect IGRP, and ro
uter 4 is running IGRP on a physical Frame Relay interface.
That will solve this part of the problem:
"also, if you look at the routing table in r5 200.200.200.0 is coming from
r4 when it should really be coming from r2?"
fabricio
---------- Original Message ----------------------------------
From: Andrew Short <ashort@wingedwheel.net>
Reply-To: Andrew Short <ashort@wingedwheel.net>
Date: Wed, 28 Feb 2001 09:18:01 -0500 (EST)
>
>Split Horizon applies only to distance vector protocols.
>
>On Wed, 28 Feb 2001, Fabricio Aponte wrote:
>
>> Steve,
>>
>> You are running an issue with Split Horizon. Do a show ip int s x on the
>> hub router. Make sure that it is off on the hub subinterface (I am sure you
>> already thought of that though). Then go to the spoke routers and do the
>> same. Split Horizon is OFF by default on Frame Relay physical interfaces,
>> which is causing your loop.
>>
>> Regards,
>>
>> Fabricio
>>
>> -----Original Message-----
>> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
>> Steven Weber
>> Sent: Tuesday, February 27, 2001 10:34 PM
>> To: CCIE GROUP; Kotte, Christopher
>> Subject: RE: can't see OSPF routes..
>>
>>
>>
>> also, if you look at the routing table in r5 200.200.200.0 is coming from
>> r4 when it should really be coming from r2?
>>
>> I can't figure that one out either
>>
>> Steve
>>
>>
>> ----- Original Message -----
>>
>> From: Kotte, Christopher
>>
>> To: CCIE GROUP
>>
>> Sent: 2/27/01 11:00:31 PM
>>
>> Subject: RE: can't see OSPF routes..
>>
>>
>>
>>
>>
>> a little more information would be helpfull...
>>
>>
>>
>> what routes do you think should be showing up on r5? could you
>> provide an
>>
>> example? have you tried "clea ip route * ? try
>> rebooting routers...should
>>
>> the routes be intra-area or external?
>>
>>
>>
>>
>>
>>
>>
>> -----Original Message-----
>>
>> From: Steven Weber
>>
>> To: CCIE GROUP
>>
>> Sent: 2/27/01 7:33 PM
>>
>> Subject: can't see OSPF routes..
>>
>>
>>
>>
>>
>> I have this really weird problem, r5 is the hub r3 and r6 are spokes.
>> r5
>>
>>
>>
>> has formed an adjacency with both of them, however none of their
>> routes
>>
>> are
>>
>> showing up on r5? Can someone please shed some light?
>>
>>
>>
>> Thanks,
>>
>>
>>
>>
>>
>>
>>
>> --- Steven Weber
>>
>>
>>
>> --- itweber@earthlink.net
>>
>>
>>
>> --- EarthLink: It's your Internet.
>>
>>
>>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:09 GMT-3