From: K. Radecki (kradecki@xxxxxxxxx)
Date: Mon Feb 26 2001 - 01:17:55 GMT-3
Mark, what's DSPU? Thanks, Kurt
-----Original Message-----
From: nobody@groupstudy.com
[mailto:nobody@groupstudy.com]On Behalf Of
Ronnie Royston
Sent: Saturday, February 24, 2001 12:11 PM
To: 'Mark Beck '; 'Tariq Sharif ';
'Ccielab@Groupstudy. Com '
Subject: RE: How to Test DLSw+
A few months ago, I was playing around with DLSw and
observed that IPX snap
or sap, I can't remember, frames were picked up by
DLSw sucessfully (it
pinged). You could probably test atleast the dlsw mac
filters this way.
-----Original Message-----
From: Mark Beck
To: Tariq Sharif; Ccielab@Groupstudy. Com
Sent: 2/23/01 3:20 AM
Subject: RE: How to Test DLSw+
DSPU is a good to emulate a SNA connection.
Regards,
Mark
----- Begin Included Message -----
To test a DLSw connection you brought up (could be
RSRB as well)
(ie to see some real stuff going through)
you can use the following setup.
----- Begin Included Message -----
<<---
R1(HOST)--t/r--R2--DLSw--R3--t/r--R4(PU)
In the above topology R2 and R3 are dlsw peers.
R4 is trying to connect to R1 using LLC2 as
as its transport for SNA..
You can replace the tokenrings with ethernets,
and leave the below config untouched
If you change only one side do not forget the
bitswapping :
http://www-tac.cisco.com/TOOLS/Applications/bitswap.html
Sending Router (emulating SNA PU) -> R4
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
dspu host TESTDLSW xid-snd 01712345 rmac
4000.3745.0001 rsap 4 lsap 4
interface TokenRing0
dspu enable-host lsap 4
dspu start TESTDLSW
end
Receiving Router (emulating Mainframe) -> R1
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
dspu pu HOST xid-rcv 01712345
interface TokenRing0
mac-address 4000.3745.0001
dspu enable-pu lsap 4
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Commands to use :
show dlsw peer
show dlsw reach
show dlsw circuit detail
show llc
show source
debug dlsw core
debug token ring
----- End Included Message -----
> -----Original Message-----
> From: nobody@groupstudy.com
[mailto:nobody@groupstudy.com]On Behalf Of
> Tariq Sharif
> Sent: 22 February 2001 18:57
> To: Ccielab@Groupstudy. Com
> Subject: How to Test DLSw+
>
>
> Any ideas on how to test DLSw+, other than 2
Token-Ring PCs
(Win95/NT4) with
> NetBEUI? e.g. can you do reasonably thorough testing
without PCs? Its
a pain
> getting PCs setup etc
>
> Many thanks & regards.
>
> Tariq Sharif
>
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:01 GMT-3