From: Steven Weber (itweber@xxxxxxxxxxx)
Date: Tue Feb 20 2001 - 17:12:59 GMT-3
Is that all there is to configuring NTP?
Chuck Larrieu wrote:
> Nothing special needed other than what you mention
>
> Sample I completed recently - worked fine:
>
> NTP server config
> ----------------------
> ntp master
>
> NTP client config
> ----------------------
> ntp server 137.20.20.1
>
> does take about 10 minutes or so to synch. did you set the correct time and
> date on the server? Clock set command?
>
> Chuck
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> sanjay
> Sent: Tuesday, February 20, 2001 10:29 AM
> To: ccielab@groupstudy.com
> Subject: NTP Configuration
>
> Is there any special commands to configure NTP across Frame Relay. One =
> of my routers is set as an NTP Master and I have NTP Broadcast command =
> setup on the serial interface that goes to the Frame cloud. The other =
> router is setup as NTP Server with the NTP Masters IP address and also =
> has the NTP Broadcast client command . The clock won't sync. I have =
> turned the interface on/off, but it still won't sync. It has been over =
> 24 hours since I configured it. Any ideas ??
>
> thanks,
> Sanjay
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:54 GMT-3