ATM SVC's

From: Peter (peter@xxxxxxxxx)
Date: Tue Feb 20 2001 - 01:32:33 GMT-3

• Next message: Simon Baxter: "RE: Bootcamp Lab 3 ( yes I checked the archives )"
• Previous message: Chuck Larrieu: "Bootcamp Lab 3 ( yes I checked the archives )"
• Next in thread: Simon Baxter: "RE: ATM SVC's"
• Maybe reply: Simon Baxter: "RE: ATM SVC's"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
 Hello again,

When creating ATM SVC's, how do you come up with NSAP addresses or ESI
addresses? Can you make them up? If not, what show command displays them?
If I do a 'sho atm ilmi-status' I get the following:

r4#sho atm ilmi-status

Interface : ATM0/0 Interface Type : Private UNI (User-side)
ILMI VCC : (0, 16) ILMI Keepalive : Disabled
ILMI State: UpAndNormal
Peer IP Addr: 0.0.0.0 Peer IF Name: ATM12/0/3
Peer MaxVPIbits: 8 Peer MaxVCIbits: 14
Active Prefix(s) :
47.0091.8100.0000.00e0.feb6.c501
r4#

If I then try the 47.... prefix I get the output below. What do I add,
truncate, or do different?

r4(config)#int atm 0/0
r4(config-if)#atm nsa
r4(config-if)#atm nsap-address 47.0091.8100.0000.00e0.feb6.c501
% Incomplete command.

r4(config-if)#atm esi-address 47.0091.8100.0000.00e0.feb6.c501
                                               ^
% Invalid input detected at '^' marker.

r4(config-if)#

As always, your help is appreciated.

Peter

• Next message: Simon Baxter: "RE: Bootcamp Lab 3 ( yes I checked the archives )"
• Previous message: Chuck Larrieu: "Bootcamp Lab 3 ( yes I checked the archives )"
• Next in thread: Simon Baxter: "RE: ATM SVC's"
• Maybe reply: Simon Baxter: "RE: ATM SVC's"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:53 GMT-3