From: Dan (dp595@xxxxxxxxxxxxx)
Date: Sat Feb 17 2001 - 18:49:19 GMT-3
This was my first response. I think it went into a black hole or something:
> You can also "redistribute connected" under the igrp process, although if
> the only connected network you want to advertise is the loopback, you'll
> have to filter the other connected networks from being redistributed into
> igrp (I believe this holds true even if you have all other connected
> interaces designated as passive interfaces under the IGRP process, as
> passive interface only stops 'outgoing' IGRP advertisements on that
> interface).
>
> Erick's solution is much simpler and the best way to go in "most" cases,
> although "redistributing connected" is something you should possess
> knowledge of in case you need it. For example, if you had 300 interfaces
in
> a router, you might not want to enter a "network x.x.x.x" command for
every
> interface under the IGRP process. It would probably be better to just
> redistribute the connected networks/subnets and filter as apporpriate.
>
>
> Dan Pontrelli
> Customer Installation Engineer - Verio NYC
> CCNP, MCSE, CNA
>
>
> ----- Original Message -----
> From: "Erick B." <erickbe@yahoo.com>
> To: "Jonghwan Hyon" <jerry@datacraft-korea.com>; <ccielab@groupstudy.com>
> Sent: Saturday, February 17, 2001 4:09 PM
> Subject: Re: How advertise loopback interface in IGRP update?
>
>
> > Just need to put the IP network you assigned to the
> > loopback under 'router igrp #' and it'll work fine.
> >
> > Check to make sure the IP networks are correct under
> > router igrp and that you specify the network under the
> > ethernet/serial/whatever interface connecting to other
> > router running IGRP on its interface connecting to
> > you.
> >
> > --- Jonghwan Hyon <jerry@datacraft-korea.com> wrote:
> > > Hi,
> > > I setup loopback interface and run IGRP routing
> > > protocol.
> > > I want to advertise the network set on loopback
> > > interface,
> > > but it is not advertized in IGRP!
> > > What I do miss? or there is a mean to advertise the
> > > loopback in IGRP?
> > >
> > > Sorry, my poor English!
> > > regards,
> > > ***********************************************
> > > Jonghwan Hyon(jerry), CCNP/CCDP
> > > Tel : 8242-487-4272
> > > Fax : 8242-487-4273
> > > Mobile : 8211-437-8883
> > > e-mail : jerry@datacraft-korea.com
> > > ***********************************************
> > >
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:52 GMT-3