Re: How advertise loopback interface in IGRP update?

From: Erick B. (erickbe@xxxxxxxxx)
Date: Sat Feb 17 2001 - 18:09:31 GMT-3

• Next message: Murphy, Brennan: "Off Topic: WTB 10 AUI to 10BaseT transceivers"
• Previous message: Chuck Larrieu: "RE: Weird problem..."
• Maybe in reply to: Jonghwan Hyon: "How advertise loopback interface in IGRP update?"
• Next in thread: Dan: "Re: How advertise loopback interface in IGRP update?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Just need to put the IP network you assigned to the
loopback under 'router igrp #' and it'll work fine.

Check to make sure the IP networks are correct under
router igrp and that you specify the network under the
ethernet/serial/whatever interface connecting to other
router running IGRP on its interface connecting to
you.

--- Jonghwan Hyon <jerry@datacraft-korea.com> wrote:
> Hi,
> I setup loopback interface and run IGRP routing
> protocol.
> I want to advertise the network set on loopback
> interface,
> but it is not advertized in IGRP!
> What I do miss? or there is a mean to advertise the
> loopback in IGRP?
>
> Sorry, my poor English!
> regards,
> ***********************************************
> Jonghwan Hyon(jerry), CCNP/CCDP
> Tel : 8242-487-4272
> Fax : 8242-487-4273
> Mobile : 8211-437-8883
> e-mail : jerry@datacraft-korea.com
> ***********************************************
>
>

• Next message: Murphy, Brennan: "Off Topic: WTB 10 AUI to 10BaseT transceivers"
• Previous message: Chuck Larrieu: "RE: Weird problem..."
• Maybe in reply to: Jonghwan Hyon: "How advertise loopback interface in IGRP update?"
• Next in thread: Dan: "Re: How advertise loopback interface in IGRP update?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:51 GMT-3