From: Rahmlow, Howard F. (howard.rahmlow@xxxxxxxxxx)
Date: Thu Feb 15 2001 - 10:30:33 GMT-3
You can also change the dead time. Play with it on an interface, you will
see the hello time change also. Then make sure both ends of the link match.
Howard
-----Original Message-----
From: Halaska, David [mailto:David.Halaska@getronics.com]
Sent: Thursday, February 15, 2001 8:23 AM
To: 'zhuqingliu'; ccielab
Subject: RE: change ospf hello interval w/o ip ospf command
You could change the ospf network type. Mostly useful in frame-relay. This
will change the hello and dead timers since the dead timer is 4 times the
hello timer. Broadcast and point to point will have timers of 10 and 40.
Non-broadcast will be 30 and 120. You can see this information if you do a
show ip ospf interface.
The command to change the network type is and interface command:
ip ospf network [network type]
Hope this helps
David Halaska
-----Original Message-----
From: zhuqingliu [mailto:zql@liming.com]
Sent: Monday, February 12, 2001 7:36 PM
To: ccielab
Subject: change ospf hello interval w/o ip ospf command
Hi, Group,
I encounter an senario, to change the hello interval without ip ospf
command.
Best regards
Perry.Zhu
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:49 GMT-3