From: Alan Basinger (abasinge@xxxxxxxxxx)
Date: Mon Feb 12 2001 - 18:22:40 GMT-3
Or you can use the ATM OC3 MM interface and cross over the fiber for the
same effect. Just add clock to one side.
Alan
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Johnny Gorham
Sent: Monday, February 12, 2001 8:30 AM
To: Tariq Sharif
Cc: Ccielab@Groupstudy. Com
Subject: Re: ATM bits
Hi,
If you have the NM-4T1-IMA cards for the 2600/3600, then you can do back to
back atm without an atm switch, with a t1 crossover cable. The same can be
accomplished with the mc3810-v (v3) router that has a t1 port. With atm
software installed you can turn the t1 controller into a logical atm0
interface
with this command.
conf t
controller t1
modeatm
end
sh runn
Tariq Sharif wrote:
> Hi Group!
>
> I'm using 4500M & 3620/2640. What ATM modules could I use? Which
combination
> is cheaper?
>
> People have said it is cheaper to buy non ATM (e.g. Lucent etc) than Cisco
> LS series. Where could I look for these?
>
> Many thanks & regards.
>
> Tariq Sharif
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:46 GMT-3