From: Devender Singh (devender.singh@xxxxxxxxxxxxxx)
Date: Sat Feb 10 2001 - 10:32:05 GMT-3
Scott,
can you r3 routes on r5 and vice-versa
Devender Singh
BE(Hons), CCNP
IP Solution Specialist
-----Original Message-----
From: Sandy Thielamay [mailto:sthielamay@totality.com]
Sent: Sunday, 11 February 2001 12:15
To: 'Scott King '; 'ccielab@groupstudy.com '
Subject: RE: OSPF-IGRP Redist.
subnetting...remember you are dealing with classful and classless protocol.
Remember FLSM and VLSM..If you are using any of the scenario above I would
summarize the OSPF routes on the ASBR and see what happen when it goes into
IGRP. Make sure when you are redistributing you are following the protocol's
metric..i.e igrp bandwith,delay etc.....
Hope this help
Cheers,
Sandy
-----Original Message-----
From: Scott King
To: ccielab@groupstudy.com
Sent: 2/9/2001 5:13 PM
Subject: OSPF-IGRP Redist.
Hey All,
Setup is this:
r5---fr---r4---hdlc---r1---token---r3
Between r5 and r4 is OSPF area 0. Between r4 and r3 (including r1) is
IGRP AS 10. Two-way redistribution on r4. Routes attached to r3 show
up in r5's table, but I can't ping them.
Suggestions?
--R. Scott King Network Consulting Engineer Cisco Systems, Inc. Advanced Network Support - SP 9155 E. Nichols Avenue Suite 400 Englewood, CO 80112 USA 919.949.8425
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:44 GMT-3