From: Larry Roberts (lroberts22@xxxxxxxxxx)
Date: Fri Feb 09 2001 - 01:37:21 GMT-3
The router-id command is just a way to specify a certain IP address as the
router-id, rather than relying on the highest loopback address. If the
router is running IOS 12.0 and the documentation does not specifically tell
you not to use the router-id command, I would use it. Impressing the proctor
may get you somewhere as I know a well-known CCIE that passed with a 75.5.
The proctor gave him the half of a point.
Sincerely,
Larry Roberts
----- Original Message -----
From: Erick B. <erickbe@yahoo.com>
To: Larry Roberts <lroberts22@uswest.net>; chenriqu <chenriqu@home.com>;
<ccielab@groupstudy.com>
Sent: Thursday, February 08, 2001 9:19 PM
Subject: Re: OSPF router-id command
>
> I would follow what the lab is asking for... anything
> extra may be pushing your luck. Impressing the proctor
> may not get you any farther but maybe it will... if
> you really want to then I would ask.
>
> --- Larry Roberts <lroberts22@uswest.net> wrote:
> > This is a new command in IOS 12.0. If your routers
> > are running 12.0 I think it would be a good idea to
> > use this command (You may even impress the
> > proctor!). FYI - BGP has a similar command in IOS
> > 12.0.
> >
> > Sincerely,
> > Larry Roberts
> >
> > ----- Original Message -----
> > From: "chenriqu" <chenriqu@home.com>
> > To: <ccielab@groupstudy.com>
> > Sent: Thursday, February 08, 2001 1:40 PM
> > Subject: OSPF router-id command
> >
> >
> > > Hello,
> > >
> > > Is it safe to use this command in the lab. I think
> > this is better than
> > using
> > > loopbacks for you RIDS. What do you guys think?
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:42 GMT-3