From: David Goldsmith (dgoldsmi@xxxxxxxxx)
Date: Thu Feb 08 2001 - 13:31:48 GMT-3
Tariq,
http://www.cisco.com/warp/public/701/59.html
Dave
Tariq Sharif wrote:
> Group
>
> I've got it sorted using PCMCIA flash card. It was n't seating properly,
> after trying slot0/1 got it working. For interest...unfortunately, tftpdnld
> is not present on 3620. I've used it on 2610. Other option I've used is
> Router Software Loader (RSL).
>
> Closest to tftpdnld is xmodem command.Does anyone know how to use xmodem
> comamnd, syntax etc?
>
> Many thanks & regards.
>
> Tariq Sharif
>
> -----Original Message-----
> From: Jim Brown [mailto:Jim.Brown@CaseLogic.com]
> Sent: 08 February 2001 15:36
> To: 'Tariq Sharif'; Ccielab@Groupstudy. Com
> Subject: RE: 3620 Boot Problem
>
> Tariq,
>
> On a 2600 the dnld command allows you to use and Ethernet interface to tftp
> download an image. You use the set commands to specify interface parameters
> and gateway.
>
> There was a document on CCO about "disaster recovery". I'm assuming this
> might also apply to the 3600.
>
> -----Original Message-----
> From: Tariq Sharif [mailto:tariq_sharif@btinternet.com]
> Sent: Thursday, February 08, 2001 8:22 AM
> To: Ccielab@Groupstudy. Com
> Subject: 3620 Boot Problem
>
> Managed to wipe 3620 flash. Now it goes into ROMMON at bootup. Can't see any
> commands to download IOS from TFTP server. The closet is xmodem. Here is the
> list:
>
> rommon 4 > ?
> alias set and display aliases command
> boot boot up an external process
> break set/show/clear the breakpoint
> confreg configuration register utility
> cont continue executing a downloaded image
> context display the context of a loaded image
> cookie display contents of cookie PROM in hex
> dev list the device table
> dir list files in file system
> dis disassemble instruction stream
> dnld serial download a program module
> frame print out a selected stack frame
> help monitor builtin command help
> history monitor command history
> meminfo main memory information
> repeat repeat a monitor command
> reset system reset
> set display the monitor variables
> stack produce a stack trace
> sync write monitor environment to NVRAM
> sysret print out info from last system return
> unalias unset an alias
> unset unset a monitor variable
> xmodem x/ymodem image download
> rommon 5 >
>
> Tried Router Software Loader but no luck. Any ideas?
>
> Many thanks & regards.
>
> Tariq Sharif
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:42 GMT-3