From: Rahmlow, Howard F. (howard.rahmlow@xxxxxxxxxx)
Date: Tue Feb 06 2001 - 20:28:05 GMT-3
What version of the IOS are you running. Some of the newer 12.1 versions
will allow you to create a point-to-multipoint tunnel. I got it to work
once, with IP. I assume it would work with IPX. You have to use the tunnel
mode command, and hit the ? mark. The default is point-to-point, or IP.
Good luck
Howard
-----Original Message-----
From: Adrian C. Vattuone [mailto:avattuone@arnet.com.ar]
Sent: Tuesday, February 06, 2001 6:21 PM
To: Vikas Gupta; ccielab@groupstudy.com
Subject: Re: IPX single network with hub and spoke
What about "moving" the IPX network to a loopback an using "a diferent
network" into each tunnel ???
Regards,
Adrian
----- Original Message -----
From: "Vikas Gupta" <vicky_gupta1803@yahoo.com>
To: <ccielab@groupstudy.com>
Sent: Tuesday, February 06, 2001 12:04 PM
Subject: IPX single network with hub and spoke
> Hello Group,
>
> I am working on a scenario where I have 2 spokes and a
> hub and the requirement is to run IPX with single
> network number without using IPX routing on FR
> interfaces. I know that we need some kind of tunneling
> here but don't know how to get single network
> requirement since hub will have two tunnel interfaces
> and IOS won't let me put same IPX net on both of them
> as they are routed interfaces. Thoughts??
>
> Vikas
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:39 GMT-3