From: Kevin Baumgartner (kbaumgar@xxxxxxxxx)
Date: Fri Feb 02 2001 - 18:27:07 GMT-3
Actually I tried using a router (on the other side of the framerelay) as the
tftp server. Using tftp-server flash:config. Had no success doing this.
Only when I went back to a external tftpserver could I get autoinstall to
work. Plus all the Cisco configurations that I have seen for autoinstall
for ethernet or framerelay show a external tftpserver.
Maybe this is some "magic" to get this to work using a router as the
tftpserver other than I what I mentioned above but it doesn't seem possible.
Kevin
At 04:01 PM 2/2/01 -0500, Brian Hescock wrote:
>Something I've been thinking about trying in the lab today, just for sh**s
>and grins is putting the two config files on the flash and add two
>tftp-server commands (on the existing router, not the new router). I
>wouldn't need the ip helper address command. Not sure if it will
>work but I don't know why not.
>
>B.
>
>On Fri, 2 Feb 2001, Kevin Baumgartner wrote:
>
> > I have done it and I believe I posted something to the group a while back.
> > Note for autoinstall to work you need a tftp server.
> >
> > Kevin
> >
> > At 02:17 PM 2/2/01 -0500, Brian Hescock wrote:
> > >I noticed in the archive that some people had questions if you could do
> > >autoinstall over frame using point-to-point, no one had tried it. I read
> > >over the doc on univercd (search on "autoinstall") and you can do it:
> > >
> > >4R3(config-subif)#frame interface-dlci 105 prot ip 10.1.1.1
> > >
> > >10.1.1.1 is the ip address of the remote router that's being installed.
> > >
> > >But now to actually try it (should work).
> > >
> > >Brian
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:34 GMT-3