From: Halaska, David (David.Halaska@xxxxxxxxxxxxx)
Date: Tue Jan 30 2001 - 17:04:27 GMT-3
Try ip ospf network point-to-point in the loopback interface.
also can use the area range if the test tells you not to use that command.
You can also do redistribute connected with a route map to only redistribute
that network, then it will show up as /24 network.
David Halaska
-----Original Message-----
From: Elver Sena [mailto:cled@usa.net]
Sent: Tuesday, January 30, 2001 1:35 PM
To: ccielab@groupstudy.com
Subject: Loopback, OSPF, and 32 mask
Hi,
I've been looking for an answer to this and I can't seem to find it. I =
looked in the archives, Cisco website, Thomas book, ...
I have a loopback with a mask of 32 and advertised on OSPF. All other =
OSPF routers were able to see this unicast address and put it in the =
routing table.
I then changed the mask of the same loopback to 24, and made the =
appropiate "network..." change in OSPF. No OSPF router is now putting =
the loopback in the routing table but they do see the router link for =
the loopback's network in the OSPF database (LSA Type 1).
I once heard that to make OSPF advertise a network mask on a loopback =
(other than 32) an additional command must be added. Does any one have =
any ideas?
Thanks,
Elver
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:49 GMT-3