From: Support (support@xxxxxxxxxxxxxxxx)
Date: Thu Jan 25 2001 - 10:35:53 GMT-3
- VLAN X will contain the LANE interface which is 155Mbps.
The closest Ethernet speed on module 2 available is 100Mbbs.
- There was a correction for the FastEtherChannel issue.
(Corrected Page 56)
To enable and disable ports, port speed, and port duplex settings,
configure the following:
(S2)
S2> (enable) set port disable 2/1-24
S2> (enable) set port enable 2/3-4,2/7-8,2/12-13,2/17-18,2/22-23
Ports 2/2-3,2/7-8,2/12-13,2/17-18,2/22-23 enabled.
S2> (enable)
S2> (enable) set port speed 2/1-24 10
Ports 2/1-24 transmission speed set to 10Mbps.
S2> (enable) set port speed 2/3-4,2/12-13,2/18,2/22-23 100
Ports 2/3-4,2/12-13,2/18,2/22-23 transmission speed set to 100Mbps.
S2> (enable) set port duplex 2/1-24 half
Ports 2/1-24 set to half-duplex.
S2> (enable) set port duplex 2/3-4 full
Ports 2/3-4 set to full-duplex.
(Corrected Page 63,219,235)
set port speed 2/1-2,2/5-11,2/14-17,2/19-21,2/24 10
set port speed 2/3-4,2/12-13,2/18,2/22-23 100
set port duplex 2/3-4 full
set port duplex 2/1-2,2/5-24 half
--- ----- ---
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Les Hardin
Sent: Wednesday, January 24, 2001 10:38 PM
To: ccielab@groupstudy.com
Subject: SolutionLabs Catalyst config question
Hey folks,
I must be missing something easy, but could someone who's gone through the
SolutionLabs lab Scenario 2-1 please explain to me the thinking behind
making ports 2/3-4 10 Mbps half duplex when the requirement is for making
it a fast etherchannel? I see the creation of the channel, but why not 100
full duplex? Also, why was VLAN X considered 100Mps? Thanks.
Les
CCNP+Voice & ATM, CCDP
18 April 2001, Halifax
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:43 GMT-3