From: Robert DeVito (robertdevito@xxxxxxxxxxx)
Date: Fri Jan 19 2001 - 01:33:08 GMT-3
I can't find Mark 1 Gravity mount on the doc CD....
----Original Message Follows----
From: "Hardenstein, Richard" <Richard.Hardenstein@schwab.com>
Reply-To: "Hardenstein, Richard" <Richard.Hardenstein@schwab.com>
To: "'Jarrod Mills'" <jarrod.mills@bellnetworks.com>, "Murphy,
Brennan" <Brennan_Murphy@nai.com>, ccielab@groupstudy.com
Subject: RE: M4 Phillips countersunk-head screws
Date: Thu, 18 Jan 2001 15:20:59 -0800
M4 is a metric # 4 screw, analogous to a 6-32 English screw (but not
compatible!!!). Phillips is obvious, countersunk means the head tapers from
a flat top to the threaded body of the screw at about a 45-60 degree angle.
A working substitute is a Mark 1 Gravity mount.
Best of luck!
Rich
-----Original Message-----
From: Jarrod Mills [mailto:jarrod.mills@bellnetworks.com]
Sent: Thursday, January 18, 2001 3:12 PM
To: Murphy, Brennan; ccielab@groupstudy.com
Subject: Re: M4 Phillips countersunk-head screws
Big hammer and duct tape!
----- Original Message -----
From: "Murphy, Brennan" <Brennan_Murphy@NAI.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, January 18, 2001 4:53 PM
Subject: M4 Phillips countersunk-head screws
> Im putting my practice lab together and the Cat 5005 requires
> M4 Phillips countersunk-head screws as per:
>
>
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/hardware/install
> g/04instal.htm#xtocid43718
>
> I called a couple hardware stores including Home Depot and no one knew
what
> these were or even if they had any. Any recommendations? For the
> uninitiated,
> these are the screws used to attach the L brackets to either side of the
> switch.
>
> -bm
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:34 GMT-3