From: jeffkesemeyer (jeffkesemeyer@xxxxxxxxxxxxx)
Date: Wed Jan 17 2001 - 23:09:17 GMT-3
int eth 0
ip address 10.10.10.10 255.0.0.0
I happen to have one myself, you almost have to spell everything out.
If you have ipx on it the command would be novell network versus ipx
network.
I started on the version so I am familiar with most of the commands :)
write network = copy runn tftp
Funny, back then the command reference book would fit in my back pocket.
Jeff
Here is a copy of my config...
Current configuration:
version 9.14
hostname r5
enable-password cisco
boot system flash
no ip domain-lookup
novell routing 0000.3010.ed9c
source-bridge ring-group 340
interface Serial 0
no ip address
interface TokenRing 0
ip address 10.34.1.3 255.255.0.0
ring-speed 16
novell network 400
source-bridge 3 5 340
interface BRI 0
no ip address
shutdown
!
interface Loopback 0
ip address 130.10.2.7 255.255.255.0
router igrp 1
network 130.10.0.0
router ospf 1
network 10.34.1.0 0.0.255.255 area 0.0.0.3
network 145.50.50.5 0.0.255.255 area 0.0.0.3
/* This is in area 3 */
ip name-server 255.255.255.255
banner motd ^C
v9.12 3205
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Rich
Sent: Wednesday, January 17, 2001 8:33 PM
To: ccielab@groupstudy.com
Subject: 9.1 config commands
Since I've only been using IOS since version 11.1 I have no clue how to IP
an Ethernet interface on a 3102 running 9.14 code.
Any help would be appreciated.
Thanks
Rich
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:33 GMT-3