From: Claude-Vincent (claude_vincent@xxxxxxxxx)
Date: Mon Jan 15 2001 - 07:30:03 GMT-3
Dear all,
I am playing with an ISDN line and I don't succeed to make it work! Does =
anyone know what it means?
Hub#ping 10.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.1.1, timeout is 2 seconds:
1d07h: ISDN BR0: TX -> SETUP pd =3D 8 callref =3D 0x0D
1d07h: Bearer Capability i =3D 0x8890
1d07h: Channel ID i =3D 0x83
1d07h: Called Party Number i =3D 0x80, 'XXXX', Plan:Unknown, =
Type:Un
known
1d07h: ISDN BR0: RX <- CALL_PROC pd =3D 8 callref =3D 0x8D
1d07h: Channel ID i =3D 0x89
1d07h: ISDN BR0: RX <- ALERTING pd =3D 8 callref =3D 0x8D.
1d07h: ISDN BR0: RX <- CONNECT pd =3D 8 callref =3D 0x8D
1d07h: ISDN BR0: HOST_CONNECT: VOICE ERROR: Bearer capability not =
available(0x3A
): bchan 0, call id 0x800D....
Success rate is 0 percent (0/5)
Hub#u all
All possible debugging has been turned off
Hub#sh dial
BRI0 - dialer type =3D ISDN
Dial String Successes Failures Last DNIS Last status
XXXX 0 0 00:00:20 failed
0 incoming call(s) have been screened.
0 incoming call(s) rejected for callback.
BRI0:1 - dialer type =3D ISDN
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is idle
BRI0:2 - dialer type =3D ISDN
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is idle
Thanks
Vincent
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:30 GMT-3