From: Thierry MARTIN (tmartin@xxxxxxx)
Date: Mon Jan 15 2001 - 07:19:09 GMT-3
Hi,
you must have "ENTREPRISE IOS"
A+
thierry
>>> Jason Whelan <Jasonw@logic.bm> 13/01/01 17h37 >>>
Hi All,
Since I don't have a router with 4 serial int, I want to set up two routers
as a frame switch for mesh connectivity.
I have seen an article describing using a tunnel between two 2501's which
basically aggregates the two routers into one 4 port frame switch.
Problem is, when I config the routers interface frame-relay route statments,
ie frame-relay route 200 interface tunnel0 250, the router doesn't like the
command.
I am not using two 2501's, but a 3810 to a 2514.
Is this the problem?
I am sure someone out there has run into this problem.
Cheers
Jason
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:30 GMT-3