From: Stephen Masraum (masraum@xxxxxxxxxx)
Date: Sun Jan 14 2001 - 22:07:42 GMT-3
take out the Frame-relay interface-dlci commands and replace them with map
statements. You'll need map statements for the remote sides and also a map
statement for your local int.
You can't ping multipoint interfaces unless they are mapped.
Steve
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Sam Pilot
Sent: Sunday, January 14, 2001 6:47 PM
To: 'CCIE_Lab Groupstudy List'
Subject: Pinging a Local Multipoint Subinterface.
Hello Friends
I have configured a Frame Relay Multipoint subinterface on a Serial
interface.
What should I configure on the router so that I am able to Ping the ip
address of that interface.
This is my config
interface Serial0.1 multipoint
ip address 172.168.111.1 255.255.255.0
frame-relay interface-dlci 503
frame-relay interface-dlci 506
503 and 506 are the DLCI's pointing to my spoke Routers.
I am able to ping my remote spokes.
Regards
Sam
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:29 GMT-3