From: Jason Whelan (Jasonw@xxxxxxxx)
Date: Sun Jan 14 2001 - 15:44:12 GMT-3
Thanks to all who replied to previous post.
I took the advice and upgraded my IOS to enterprise, and now the router
stays up, (it would boot up, reset etc etc)
What I am trying to get working is using two routers as 1 frame relay switch
(I don't have a router with 4 serial ports)
I am connecting a 2651 to a 2514 using a tunnel interface linking the
ethernet ports.
I then make the neccesary frame relay switching commands ie
encap,lmi-type,intf-dce, and frame-relay route dlci intf dlci commands.
On the other router I do the same.
The tunnel is up, and the routers that connect to the first frame-switch
router work fine, see dlci,lmi can ping etc.
Problem-the two rtrs connected to the other half of the frame-switch (2514)
have their dlci states inactive, and I have tried
everything-subinterfaces,frame-relay map etx to no avail-it's as if the dlci
assignments are not flowing across the two-rtr fr switch.
Basically:
RTR-A------2651(fr-sw1)--tunel0--2514(fr-sw2)--------RTR-C
| |
| |
RTRB RTRD
Basically I am trying to combine two routers into a 4-port frame switch
as per a document I found on ccprep.com
Has anyone got this to work?
Cheers
Jason
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:28 GMT-3