bgp question

From: Harbir Kohli (harbirk@xxxxxxxxxxxx)
Date: Fri Jan 12 2001 - 21:03:47 GMT-3

• Next message: Eric Fairfield: "Re: ISIS over frame-relay troubles....."
• Previous message: David Ankers: "Re: Changing the control sequence"
• Next in thread: David Wolsefer: "RE: bgp question"
• Maybe reply: David Wolsefer: "RE: bgp question"
• Maybe reply: David Wolsefer: "RE: bgp question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi

I am trying to configure bgp dampening if the interface serial 1 goes
down. I tried the following but it did not work. Does anyone know Why?
and What is the solution?

router bgp 10600
 bgp confederation identifier 200
 bgp confederation peers 10060
 bgp dampening route-map damp
route-map damp permit 10
 match interface Serial1
 set dampening 20 950 2500 80

Thanks

Harbir

• Next message: Eric Fairfield: "Re: ISIS over frame-relay troubles....."
• Previous message: David Ankers: "Re: Changing the control sequence"
• Next in thread: David Wolsefer: "RE: bgp question"
• Maybe reply: David Wolsefer: "RE: bgp question"
• Maybe reply: David Wolsefer: "RE: bgp question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:28 GMT-3