From: Allyn Baskerville (abaskerville@xxxxxxxxx)
Date: Thu Dec 28 2000 - 02:59:21 GMT-3
I've configure tunnel interfaces on two routers for nlsp routing and IPXWAN.
Basically, my configurations at each end are as follows:
interface Tunnel0
no ip address
no ip directed-broadcast
ipx ipxwan 0 unnumbered R1
ipx nlsp enable
tunnel source 172.1.11.1
tunnel destination 172.2.11.6
...
access-list 1000 deny FFFFFFFF 7
access-list 1000 permit FFFFFFFF 0
...
ipx router nlsp
distribute-sap-list 1000 in
area-address 0 0
Here is my dilemma. I would expect the distribute-sap-list under ipx router
nlsp to read "out" in order to filter SAPs outbound from this router to R2
(the other end of the tunnel). However, absolutely no SAPs are filtered to
R2 unless I change the distribute list to "in". This seems completely
backwards to me. I get the same results on both routers. Has anyone run
across this before?
Thanks - Allyn
9-10 Jan RTP
Allyn Baskerville
Production Division
Network Engineering
iBEAM Broadcasting
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:11 GMT-3