From: tom cheung (tkc9789@xxxxxxxxxxx)
Date: Sat Dec 23 2000 - 11:50:59 GMT-3
I believe that you do need IRB on either router A or C in this scenario.
>From: "Atif Awan" <atifawan@hotmail.com>
>Reply-To: "Atif Awan" <atifawan@hotmail.com>
>To: ccielab@groupstudy.com
>Subject: IPX bridging problem
>Date: Sat, 23 Dec 2000 10:06:39
>
>i was working ipx ( my weak spot :) ) when i encountered a strange problem
>that i cannot seem to solve. The relevant setup is like this :
>
>Router_A(ether0/0) --- (ether0)Router_B(serial0) --- (serial1)Router_C
>
>All the 3 routers are routing IP. Router_A and Router_C have ipx routing
>turned on too but Router_B does not have ipx routing turned on. Router_A's
>ethernet0/0 and Router_C's serial 1 both have the same IPX network number.
>Router_B has bridge-group 1 statements on both ether0 and serial 0.
>
>IPX RIP routes from Router_A are seen successfully in the ipx routing table
>of Router_C. However, updates from Router_C are not reaching Router_A. When
>i turn on debugging on Router_C it says that it is broadcasting updates out
>serial 1 but these never reach Router_A. I dont think i need IRB anywhere
>here ... why is this happening that one way traffic is going through
>successfully and the other way its not ??? Rest assured there are no IPX
>access-lists anywhere ...
>
>TIA
>Atif Awan
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:10 GMT-3