From: Lykourgiotis Paraskevas (ParaskevasL@xxxxxxxxxxxx)
Date: Fri Dec 22 2000 - 12:36:48 GMT-3
Hi,
I should suggest you, in case you are running OSPF over F/R or X.25, to make
static X.25 or F/R mappings using the "broadcast" keyword (frame-relay map
ip x.x.x.x dlci broadcast) OR define "ip ospf network point-to-multipoint
non-broadcast" under interface configuration mode.
Hope this helps.
-----Original Message-----
From: Dan Skiptunas [mailto:dskiptunas@jannon.com]
Sent: Friday, December 22, 2000 5:10 PM
To: ccielab@groupstudy.com
Subject: Re:update OSPF adjancency
Thanks for the help ,I tried all the ideas but nothing work in the end I
needed to do a wr erase and rebuild config by hand with NO changes to
original config . Has anyone else had this happen ?
----- Original Message -----
From: "Dan Skiptunas" <dskiptunas@jannon.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, December 21, 2000 11:07 AM
Subject: OSPF adjancency
> Hello,
> I am having a problem with a neighbor router not going to the full =
> state ,router is stuck in Init state , interface is configured for =
> point-to-multipoint on both ends and the remote is seeing hellos, the =
> remote shows "Init" and the host shows nothing. any ideas on how to find =
> problem ?
>
>
> Thank You,
> Dan Skiptunas
> Network Engineer
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:09 GMT-3