From: BUI, TIN T (SBCSI) (tb4565@xxxxxxx)
Date: Thu Dec 21 2000 - 14:32:37 GMT-3
Make sure ospf network type are same on both sides. I use ip ospf network
point-to-multipoint for all interfaces if I'm not using svc on Frame-relay.
Check that hello and dead timers are also the same. You can use show ip
ospf int to check for all of this.
> Tin T. Bui
> Senior Network Manager
> Network Management Center
> SBC Services Inc.
> 7337 Trade Street, Rm 1110
> San Diego, Ca 92121
> Office #: 858-886-4589
> Pager #: 858-494-0482
> Fax #: 858-549-4103
> Email: tb4565@sbc.com
>
-----Original Message-----
From: Dan Skiptunas [mailto:dskiptunas@jannon.com]
Sent: Thursday, December 21, 2000 8:07 AM
To: ccielab@groupstudy.com
Subject: OSPF adjancency
Hello,
I am having a problem with a neighbor router not going to the full =
state ,router is stuck in Init state , interface is configured for =
point-to-multipoint on both ends and the remote is seeing hellos, the =
remote shows "Init" and the host shows nothing. any ideas on how to find =
problem ?
Thank You,
Dan Skiptunas
Network Engineer
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:09 GMT-3