From: zhangxianqi (zhangxqi@xxxxxxxxxxx)
Date: Sat Dec 09 2000 - 12:18:29 GMT-3
try get the 'dialer snapshot 1' off the server,because it's use on client.
not try it,just a guess,sorry if I am wrong.
Regards
xianqi
----- Original Message -----
From: Ronnie Royston <RonnieR@globaldatasys.com>
To: <ccielab@groupstudy.com>
Sent: Saturday, December 09, 2000 1:24 AM
Subject: DDR - Snapshot Routing
> It appears to be working per the 'sho' commands but after the BRI is down
> for a couple of minutes, the RIP snapshot route ages out of the route table
> on the server side? Should I need to manipulate the RIP timers or is my
> snapshot config wrong? Thanks.
>
> SERVER SIDE:
> interface BRI0
> no ip address
> no ip directed-broadcast
> dialer pool-member 1
> isdn switch-type basic-ni
> isdn spid1 0835866201 8358662
> isdn spid2 0835866401 8358664
> !
> interface Dialer0
> ip address 17.255.255.6 255.255.255.252
> no ip directed-broadcast
> encapsulation ppp
> dialer remote-name L1
> dialer string 8358661
> dialer string 8358663
> dialer snapshot 1
> dialer pool 1
> dialer-group 1
> snapshot server 5 dialer
> ppp authentication chap
> ppp multilink
>
> L7#sho snapshot
> Dialer0 is up, line protocol is upSnapshot server
> Options: dialer support
> Length of active period: 5 minutes
> For ip address: 17.255.255.5
> Current state: active, remaining time: 5 minutes
> Connected dialer interface:
> BRI0:1
>
> CLIENT SIDE:
> interface BRI0
> ip address 17.255.255.5 255.255.255.252
> encapsulation ppp
> isdn spid1 0835866101 8358661
> isdn spid2 0835866301 8358663
> dialer map snapshot 1 name L7 broadcast 8358662
> dialer map ip 17.255.255.6 name L7 broadcast 8358662
> dialer-group 1
> snapshot client 5 8 dialer
> ppp authentication chap
> !
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:01 GMT-3