From: Justin Menga (Justin.Menga@xxxxxxxxxxxxxxxxxx)
Date: Sat Dec 09 2000 - 06:17:28 GMT-3
access your RSM:
e.g. session 3
Once in, you create interfaces to each vlan via:
interface vlan 100
no shut
ip address ..... .....
You have created a virtual interface into vlan 100. Of course the vlan must
be configured on the switch as well. You can repeat this config for each
vlan to let your RSM act as a "router on a stick".
Regards,
Justin Menga MCSE+I CCNP CCSE ASE
WAN Specialist
Computerland New Zealand
PO Box 3631, Auckland
DDI: (+64) 9 360 4864 Mobile: (+64) 25 349 599
mailto: justin.menga@computerland.co.nz
-----Original Message-----
From: Sim, CT (Chee Tong) [mailto:CheeTong.Sim@sin.rabobank.com]
Sent: Friday, 8 December 2000 12:52 a.m.
To: cisco@groupstudy.com
Cc: ccielab@groupstudy.com
Subject: how does traffic from CAT55 switch moule to Route switch module
( RSM)?
Dear all,
1)I have a cat 55 switch which got 2 X 10/100BaseTX Ethernet module and 1 X
Route Switch Module (RSM), so, I have 48 ports on the switches module and
divided into 3 VLANs some of ports were set to VLAN 1, 2 3, and the RSM
module is connect thru our WAN router to world, and RSM, the layer 3 device
is used to route the traffic between VLANs but I don't know how does the
traffic from the switches module do to RSM module as there is no cable
connection or it do internally?
2)I found my RSM module is configured 3 VLANs inteface, 100.100.100.99,
100.100.200.99, 100.100.300.99, but I can't see there are phyiscal
interface. Why?
Below shown the conf, sometarou is the switch module and SOMETAROU is the
RSM module
sometarou> sh cdp nei
* - indicates vlan mismatch.
# - indicates duplex mismatch.
Port Device-ID Port-ID Platform
-------- ------------------------------- -------------------------
------------
2/1 SOMETAROU Vlan1 cisco
RSP2
3/1 066506067(somenosuke) 3/1 WS-C5505
3/2 066506067(somenosuke) 3/2 WS-C5505
3/3 066506067(somenosuke) 3/3 WS-C5505
3/4 066506067(somenosuke) 3/4 WS-C5505
sometarou> session 2
Trying Router-2...
Connected to Router-2.
Escape character is '^]'.
********************
* Catalyst 5505 #2 *
* RSM WS-X5302 *
* SOMETAROU *
********************
User Access Verification
Password:
SOMETAROU>sh cdp nei
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Local Intrfce Holdtme Capability Platform Port ID
066507401(sometarou)Vlan1 132 T B S WS-C5505 2/1
SOMETAROU>
==================================================================
De informatie opgenomen in dit bericht kan vertrouwelijk zijn en
is uitsluitend bestemd voor de geadresseerde. Indien u dit bericht
onterecht ontvangt wordt u verzocht de inhoud niet te gebruiken en
de afzender direct te informeren door het bericht te retourneren.
==================================================================
The information contained in this message may be confidential
and is intended to be exclusively for the addressee. Should you
receive this message unintentionally, please do not use the contents
herein and notify the sender immediately by return e-mail.
==================================================================
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:00 GMT-3