From: Justin Menga (Justin.Menga@xxxxxxxxxxxxxxxxxx)
Date: Thu Dec 07 2000 - 02:00:21 GMT-3
Hi,
I am doing Bootcamp 11, and just have the following problem.
R6-----R1------R5
|
|
R3
R1, R5 and R6 are in ISIS area 00.0002 and R3 is in ISIS area 00.0001. They
are all interconnected via frame-relay point-to-point interfaces. R1 forms
adjacencies with R3 and R6 no problem, but does not form properly with R5.
In debug isis adj - I get this error:
ISIS-Adj: No usable IP interface addresses in serial IIH from Serial0.3
If I do a show clns is-neighbor:
R1#sh clns is-neigh
System Id Interface State Type Priority Circuit Id Format
R3 Se0.2 Up L2 0 00 Phase V
R6 Se0.1 Up L1L2 0 00 Phase V
0050.50C0.0400 Se0.3 Up IS 0 00 Phase V
As you can see the state is IS and not L2 or L1L2 - R5 also does not see any
ISIS routes.
Any ideas??
R1:
router isis
net 00.0002.0010.7bc2.8c72.00
int s0.1
ip router isis
int s0.2
ip router isis
int s0.3
ip router isis
int f0
ip router isis
R5:
router isis
net 00.0002.0050.50c0.0400.00
int s1/0.1
ip router isis
Regards,
Justin Menga MCSE+I CCNP CCSE ASE
WAN Specialist
Computerland New Zealand
PO Box 3631, Auckland
DDI: (+64) 9 360 4864 Mobile: (+64) 25 349 599
mailto: justin.menga@computerland.co.nz
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:59 GMT-3