From: James Chen (jr_chen@xxxxxxxxxxxxxxx)
Date: Tue Dec 05 2000 - 12:33:02 GMT-3
Hello, Sir:
I can not get the ip in newrouter from autoinstall....
my config is
existing router:
int s0/0
encap frame-relay
ip add 10.10.10.1 255.255.255.0
frame lmi-type cisco
frame map ip 10.10.10.2 100 broadcast CISCO
ip helper-address 210.59.251.236
but when I debug ip packet ,
no any packet come from newrouter to try to get config ?
I have done the autoinstall when I use hdlc encapulation successfully.
but can't with frame-relay ?
what do I miss ?
Thaks for your answer !!!
James
LUIS SERRANO SERRANO wrote:
> Hi all,
> It is the first time that i write a e-mail to groupstudy group.
> Last week i get the CCIE number # 6503 at Brussels.
> I think this mailing list has been very, very useful for me.
>
> About autoinstall, i have tested whitout broadcast parameter in frame relay m
ap command and they works also. In this test i have the ip helper address comma
nd enabled to the TFTP server's IP address.
>
> Regards
>
> >>> "Thierry MARTIN" <tmartin@ares.fr> 11/29 4:37 p.m. >>>
> Hello,
>
> for autoinstall with frame relay, you must use :
>
> - LMI cisco (default)
> - encap cisco (default)
> - only one DLCI for this destination
> - broadcast => frame-relay map ip 10.0.1.2 100 broadcast
> - address ".1 " for central router
> - address ".2" will be assign to the autoinstall router
>
> Other IP address don't run.
>
> Autoinstall don't run with VLSM
>
> A+
> thierry
> CCNA, CCDA, CCNP, specialization ATM
> Lab for February
>
> *****************************************************************************
********************************
>
> Cordialement
>
> \\\\///
> (/ @ @ /)
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:58 GMT-3