From: Ronnie Royston (RonnieR@xxxxxxxxxxxxxxxxx)
Date: Fri Dec 01 2000 - 13:27:38 GMT-3
Try putting the demand circuit on the remote side only.
-----Original Message-----
From: James Chen [mailto:jr_chen@ringline.com.tw]
Sent: Friday, December 01, 2000 6:40 AM
To: CCIE Group Study (E-mail)
Subject: [Q]OSPF Demand-Circuit over ISDN DDR
Hello, Sir:
I have big problem with OSPF Demand-Circuits.
My config is as following:
-----------------------------------------------------------
R3:
interface BRI0/0
ip address 137.1.35.1 255.255.255.252
no ip directed-broadcast
encapsulation ppp
ip ospf network non-broadcast
dialer map ip 137.1.35.2 name R5
dialer-group 1
isdn switch-type basic-5ess
ppp quality 90
ppp authentication pap
ppp pap sent-username R3 password 7 1511021F0725
router ospf 1
network 137.1.3.3 0.0.0.0 area 0
network 137.1.35.1 0.0.0.0 area 3
network 137.1.63.3 0.0.0.0 area 3
network 137.1.254.3 0.0.0.0 area 0
neighbor 137.1.35.2 priority 1
R5:
interface BRI0/0
ip address 137.1.35.2 255.255.255.252
no ip directed-broadcast
encapsulation ppp
ip ospf network non-broadcast
ip ospf demand-circuit
dialer map ip 137.1.35.1 name R3 broadcast 8358661
dialer-group 1
isdn switch-type basic-5ess
ppp quality 90
ppp authentication pap
ppp pap sent-username R5 password 7 05080F1C2243
router ospf 1
network 137.1.5.5 0.0.0.0 area 3
network 137.1.35.2 0.0.0.0 area 3
network 137.1.65.5 0.0.0.0 area 3
neighbor 137.1.35.1 priority 1
------------------------------------------------------------------------
I have continuously got the messages on both routers for each 30secs:
*Mar 2 08:53:32: OSPF: Rcv hello from 137.1.3.3 area 3 from BRI0/0
137.1.35.1
*Mar 2 08:53:32: OSPF: End of hello processing
------------------------------------------------------------------------
I don't know why I use non-broadcast network type, the hello still
occurs?
Thanks for your regards.
James
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:57 GMT-3