From: Fred Ingham (fningham@xxxxxxxxxxxxxxxx)
Date: Fri Nov 10 2000 - 15:18:52 GMT-3
I had a border peer when I tested. Examples were to answer the
original question - i.e. using the source ring-group command.
Fred
aiqun hu wrote:
>
> Fred,
>
> Did you test your config? I doubt if it works. From CD, it said that
>
> 1) dlsw peer-on-demand
> A peer-on-demand peer is a non-configured remote-peer that was connected
> because of an LLC2 session established through
> a Border Peer DLSw+ network.
>
> 2) dlsw prom-peer-defaults
> A prom-peer is a peer not configured as a remote-peer on this DLSw+ device,
> but which initiated a peer connection which
> was accepted because promiscuous peering was enabled.
>
> But from the second command, I couldn't find the option to apply port-list.
> So my guess is if u use border peer, it should work. Let me know if I am
> wrong.
>
> Thanks,
> Rena
>
> >From: Fred Ingham <fningham@worldnet.att.net>
> >Reply-To: Fred Ingham <fningham@worldnet.att.net>
> >To: zhuoyun Wu <wuzhy@adtec.com.cn>, ccielab@groupstudy.com
> >Subject: Re: about DLSW promiscuous mode
> >Date: Thu, 09 Nov 2000 14:00:28 -0500 would definFrede a source-bridge
> >ring-group (see Example 1). If you
> >only wanted certain rings to have access-from remote peers you would
> >also define a port-list and reference the port-list in a dlsw
> >peer-on-demand-defaults statement (see example 2).
> >
> >Example 1:
> >r1:
> >source-bridge ring-group 100
> >dlsw local-peer peer-id 1.1.1.1 promiscuous
> >!
> >int loop 0
> >ip address 1.1.1.1 255.255.255.0
> >!
> >int tok 0
> >source-bridge 1 1 100
> >source-bridge spanning
> >!
> >int tok 0
> >source-bridge 2 1 100
> >source-bridge spanning
> >
> >Example 2:
> >r1:
> >source-bridge ring-group 100
> >dlsw local-peer peer-id 1.1.1.1 promiscuous
> >dlsw port-list 1 tokenring 0
> >dlsw peer-on-demand-defaults port-list 1
> >!
> >int tok 0
> >source-bridge 1 1 100
> >source-bridge spanning
> >!
> >int tok 1
> >source-bridge 2 1 100
> >source-bridge spanning
> >
> >HTH, Fred.
> >
> > > zhuoyun Wu wrote:
> > >
> > > Hi : Who can tell me that if the dlsw is configurated promiscuous
> > > mode , how to set which ring join the DLSW ? thank you .
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:44 GMT-3