From: Keith T. Hall (kthall@xxxxxxxxxxxxxx)
Date: Wed Nov 08 2000 - 21:55:36 GMT-3
Assume this is for lab-only use. Try one of two ways with AutoRP and
pim sparse-mode with pim nbma:
(1) Move the 'send-rp-discovery' to the hub, leave the
'send-rp-announce' on the spoke. May not work depending on other
factors, but most suitable for a production environment.
(2) Leave both on the spoke but set up tunnels to other points of
spoke.
I tested with a join-group or via watching the route of a multicast
source on the spoke, which should appear populated with the RP info...
Keith T. Hall
Sr. Network Engineer, Service Provider Accounts
Greenwich Technology Partners
3810 Concorde Parkway, Suite 500
Chantilly, VA 20151
(703) 966-1854 Cell
(703) 222-6465 Office
(703) 222-6424 Fax
khall@greenwichtech.com
http://www.greenwichtech.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Brian
Sent: Monday, November 06, 2000 8:58 AM
To: cciemail
Subject: Repost: Multicast with RP as Spoke
This a repost from the archives. Has anyone gotten this to work?
* Subject: Multicast over Frame Relay with spoke as RP
* From: Muthu <muthumon@xxxxxxx>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:43 GMT-3