From: Eric Fairfield (ericfair@xxxxxxxxxx)
Date: Sun Nov 05 2000 - 12:53:20 GMT-3
You can add the "r-sup-only" flag to take advantage of incremental
saps without EIGRP. The command is not very clear due to the EIGRP
statement but the rsup flag uses rip.
You can also use ipx update interval {rip | sap} {value |
changes-only} in some of the more recent versions of code.
To take advantage of Enhanced IGRP's incremental SAP update mechanism
while using the RIP routing protocol instead of the Enhanced IGRP
routing protocol,
specify the rsup-only keyword. SAP updates are then sent only when
changes occur, and only changes are sent. Use this feature only when
you want to use RIP
routing; Cisco IOS software disables the exchange of route information
via Enhanced IGRP for that interface
----- Original Message -----
From: micklegao@netease.com
To: ccielab@groupstudy.com
Sent: Saturday, November 04, 2000 8:08 PM
Subject: ipx sap again
hi,
i think the command "ipx sap-incremental eigrp xx"can only be used
under ipx eigrp, it will not be functional under ipx rip.
so if i use ipx rip, how to config, so that it only send sap when
the sap changes, no preriodical sap.
thanks a lot!
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:41 GMT-3