From: radha rani (radhaccie@xxxxxxxxxxx)
Date: Fri Nov 03 2000 - 17:01:43 GMT-3
What if I have RIP enabled on the ethernet int where the secondary is
configured and run NLSP on the serial int. Will the secondary get
advertised out the serial interface. I find that the primary does, no
problem. The secondary does not.
>From: "Sam Munzani" <sam@munzani.com>
>Reply-To: "Sam Munzani" <sam@munzani.com>
>To: "radha rani" <radhaccie@hotmail.com>, <masalmon@cisco.com>,
><smorris@mentortech.com>
>CC: <ccielab@groupstudy.com>
>Subject: Re: IPX - multiple frame encapsulations on one wire
>Date: Fri, 3 Nov 2000 13:55:12 -0600
>
>NLSP does not work with secondary addresses. I mean if you do following.
>
>int e0/0
>ipx network 111
>ipx network 222 encap sap
>ipx nlsp enable
>
>ipx router nlsp
>area 0 0
>
>It will only take the primary network 111 in NLSP routing process. Will not
>take 222 in NLSP process.
>
>Sam
>
>
> > I can't seem to redistribute the secondary network into NLSP. Is this
>not
> > possible?
> >
> >
> > >From: "Sam Munzani" <sam@munzani.com>
> > >Reply-To: "Sam Munzani" <sam@munzani.com>
> > >To: "mark salmon" <masalmon@cisco.com>, "Scott Morris"
> > ><smorris@mentortech.com>
> > >CC: <ccielab@groupstudy.com>
> > >Subject: Re: IPX - multiple frame encapsulations on one wire
> > >Date: Fri, 3 Nov 2000 13:08:39 -0600
> > >
> > >I prefer subinterface because that's easy, works with NLSP as well.
>What
>if
> > >you are told not to use subinterface in lab? Give brain a little
>excercise.
> > >
> > >Sam
> > >
> > >
> > > > Update. With future releases, IPX secondary addresses will not be
> > > > supported. Practice using sub interfaces instead. Trust me.
> > > >
> > > > Scott Morris wrote:
> > > > >
> > > > > (config-if)ipx network (net) encapsulation (encap-type) secondary
> > > > >
> > > > > Enjoy!
> > > > >
> > > > > Scott Morris, MCSE, CNE(3.x), CCDP (R&S), CCIE (R&S) #4713,
>Security
> > > > > Specialization, CCNA - WAN Switching
> > > > > CCSI #21903
> > > > > smorris@mentortech.com
> > > >
> > > > --
> > > >
> > > >
> > > >
> > > > Mark Salmon
> > > > Network Support Engineer - SBC OP HQ
> > > > Cisco Systems Inc
> > > > 8735 W. Higgins Road Suite 300
> > > > Chicago IL 60631
> > > > Phone:773-695-8235
> > > > Pager:800-365-4578
> > > > email: masalmon@cisco.com
> > > > Empowering The Internet Generation.
> > > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:41 GMT-3