From: Jansen (jysh@xxxxxxxxxxxxxx)
Date: Fri Nov 03 2000 - 12:05:34 GMT-3
Hi,all
can anybody explain this for me?
i configure dlsw like this to provide loadbalance(ios 11.2.15):
dlsw local-peer peer-id 192.169.1.1
dlsw remote-peer 0 tcp 192.169.1.2
dlsw remote-peer 0 tcp 192.169.1.3
dlsw duplicate-path-bias load-balance
dlsw timer explorer-wait-time 30
dlsw bridge-group 1
r1#sh dlsw reach
....
DLSw Remote NetBIOS Name reachability cache list
NetBIOS Name status Loc. peer
ADC-GP FOUND REMOTE 192.169.1.2(2065) max-lf(1500)
192.169.1.3(2065) max-lf(1500)
CHENM FOUND REMOTE 192.169.1.2(2065)
192.169.1.3(2065)
KATHY FOUND REMOTE 192.169.1.2(2065)
192.169.1.3(2065)
PC-SERVER FOUND REMOTE 192.169.1.2(2065) max-lf(17800)
192.169.1.3(2065)
SFH FOUND REMOTE 192.169.1.2(2065)
192.169.1.3(2065)
TEAMSUN09 FOUND REMOTE 192.169.1.2(2065)
192.169.1.3(2065)
but circuit is always established on 192.169.1.2 which looks like:
r1#sh dlsw cir det
Index local addr(lsap) remote addr(dsap) state
3204448310 0003.3001.18cf(F0) 1000.040d.f5f1(F0) CONNECTED
PCEP: 15B854 UCEP: 153D90
Port:TB1 peer 192.169.1.2(2065)
Flow-Control-Tx CW:20, Permitted:25; Rx CW:20, Granted:25; Op: Repeat
Congestion: Low(02), Flow Op: Half: 0/0 Reset 0/0
RIF = --no rif--
1325400116 0003.3001.18cf(F0) 0005.93c1.44b4(F0) CONNECTED
PCEP: 6B520 UCEP: 139B9C
Port:TB1 peer 192.169.1.2(2065)
Flow-Control-Tx CW:20, Permitted:30; Rx CW:20, Granted:27; Op: Repeat
Congestion: Low(02), Flow Op: Half: 0/0 Reset 0/0
RIF = --no rif--
is there anything wrong in the configuration?
or the balance is not based on circuit?
Jansen
00-11-3
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:41 GMT-3