From: Daniel Keller (DMKeller@xxxxxxxxxxxx)
Date: Wed Oct 25 2000 - 01:46:15 GMT-3
This is definitely not as easy as it seems. I just tried this for a couple hou
rs and could not make it work. Here is the approach I would take in doing this
.
1)Enable appletalk EIGRP between R2 and R3 and RTMP and between R1 and R2.
2)Disable appletalk route-redistribution on R2 so that he does not redistribute
the R1 token ring route into EIGRP.
This works fine and when I do a show ip global on R2 it says that routes will n
ot be distributed. Then when I reload the router it goes away and for some rea
son they get redistributed again. Anyone know why? Is this an IOS thing?
I was only able to make it work when I did a no send-rtmp on the ethernet of R1
, but then both R2 and R3 don't see the R1 Token Ring route, not just R3. When
doing this, though, R1 is able to ping every address.
Any ideas?
Dan K.
>>> z z <ccie_99@yahoo.com> 10/24/00 04:28AM >>>
not so simple.
once you configure 'no rtmp-send', the serail
interface wont be up (do a show appletalk interface,
you will see appletalk protocol down).
try it
-----Original Message-----
From: pbosio@comtech.com.au
[mailto:pbosio@comtech.com.au]
Sent: Tuesday, October 24, 2000 5:19 PM
To: z z
Subject: Re: appletalk question. (again)
quite simple, don't let r3 ( token-ring router ) send
appletalk routes out the
serial interface, sort off like passive-interface for
IP.
Hi all
just found one unanswered question in the archive
(attached). Anyone knows how to do it?
Subject: Preventing Appletalk network and zone appears
in other routers WITHOUT filters?
From: "Alex Yeung" <alex.yeung@xxxxxxxx>
Date: Thu, 16 Dec 1999 11:38:39 -0800
Importance: Normal
-------------------------------------------------------------------------------
-
I have three routers r1, r2 and r3.
r1 has one serial, one token ring and one ethernet
interfaces
r2 has one ethernet and one serial interfaces
r3 has one serial, one token ring and one ethernet
interfaces
r1 and r2 area connected to the same ethernet segment
r2 is connected to r3 via serial link
r1 is not connected to r3
How do I configure the Appletalk network so that r3
can see ALL the
Appletalk
networks and zones except r1's token-ring Appletalk
network & zone WITHOUT
ANY FILTERS? NO FILTERS can be used. Can someone give
me an example w/
configs?
Thanks.
Alex Yeung, CCNP, MCSE
Network Engineer
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:29 GMT-3