From: John Conzone (jkconzone@xxxxxxxx)
Date: Tue Oct 24 2000 - 08:07:05 GMT-3
Hou, please post your config if you could, and a little diagram. I
have same setup with no luck, except I'm going router to router.
----- Original Message -----
From: Hou Li
To: ccielab@groupstudy.com
Sent: Tuesday, October 24, 2000 2:51 AM
Subject: use bridge over frame hub
I have just config a bridge over frame hub-spokes:
R1-FRSW-R2
R3
R3 is hub, dlci 100 to R1,dlci 200 to R2
R1, R2 is spoke, use s0 : dlci 100 to R3.
I config 'bridge 1' in R1&R2's e0 and s0, ' frame map bridge 100
broad' int s0,
and 'frame map bridge 100 bro','frame map bridge 200 bro' in R3's s0,
then I use a pc linking to R1's e0 can ping pc linking to R2's e0.
Don't forget use 'frame map bridge xxx ' in framerelay.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
John Conzone
Sent: Tuesday, October 24, 2000 6:28 AM
To: ccielab
Subject: bridge over frame hub
Anyone think of a way to bridge bewteen FR spokes with hub using
single multipoint interface?
Can bridge from spokes to hub fine, but can't think of a way to
get the spokes to bridge across the hub. Tunnel won't accept bridge.
May not be a way, but just checking.
Thanks!
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:29 GMT-3