From: Jack Heney (jheneyccie@xxxxxxxxxxx)
Date: Tue Oct 24 2000 - 00:40:51 GMT-3
Okay...Scratch that last email...I got it to work using IRB (I had
mismatched ends of a virtual circuit)...I got this working from spoke to
hub, but I also can't get it to work spoke to spoke. My config is as
follows (r2 is my frame-relay hub):
hostname r1
!
interface s0/0
encapsulation frame-relay
frame-relay map bridge 102 broadcast
bridge-group 1
!
interface bvi 1
ip address 10.1.1.1 255.255.255.0
!
bridge irb
bridge 1 protocol ieee
bridge 1 route ip
hostname r2
!
interface s0/0
encapsulation frame-relay
frame-relay map bridge 201 broadcast
frame-relay map bridge 203 broadcast
bridge-group 1
!
bridge 1 protocol ieee
hostname r3
!
interface s0/0
encapsulation frame-relay
frame-relay map bridge 302 broadcast
bridge-group 1
!
interface bvi 1
ip address 10.1.1.3 255.255.255.0
!
bridge irb
bridge 1 protocol ieee
bridge 1 route ip
Any ideas?
Thanks,
Jack
>From: "John Conzone" <jkconzone@home.com>
>Reply-To: "John Conzone" <jkconzone@home.com>
>To: "ccielab" <ccielab@groupstudy.com>
>Subject: bridge over frame hub
>Date: Mon, 23 Oct 2000 18:27:51 -0400
>
> Anyone think of a way to bridge bewteen FR spokes with hub using
>single multipoint interface?
> Can bridge from spokes to hub fine, but can't think of a way to get
>the spokes to bridge across the hub. Tunnel won't accept bridge. May not be
>a way, but just checking.
> Thanks!
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:29 GMT-3