From: John Conzone (jkconzone@xxxxxxxx)
Date: Sat Oct 14 2000 - 11:19:09 GMT-3
Hi, guys. Having been through the lab twice and both times
configuring the ATM part fine, I thought I understood this stuff. I
better think again. Here's my question.
When configuring a full NSAP address on a ATM interface, should I
need ILMI? I have always configured ILMI on all ATM interfaces as a
habit, but I thought that it was only used for address registration.
If I hard code an NSAP address on an itnerface and configure QSAAL,
why won't the switch route the NSAP's through the signalling pvc.
My problem is that if I configure an NSAP address on two routers
conencted to an LS1010, I can't get them to talk, with or without
ILMI.
As soon as I take the prefix from the switch and just configure
the ESI and selector, its all good.
Is there a knob on the LS1010 I haven't got turned on?
Thanks!
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:26 GMT-3