From: Brian Hescock (bhescock@xxxxxxxxx)
Date: Thu Oct 12 2000 - 16:58:15 GMT-3
You would have to at least have the enable or enable secret password set
(which I believe your question asked how to do it without any
passwords). You cannot get into enable mode when telnetting in without
having an enable or enable secret password, it's a security feature.
Brian
On Fri, 13 Oct 2000, Justin Menga wrote:
> Use the following:
>
> line vty 0 4
> no login
> no password
> privilege level 15
> exec-timeout 120
>
> The above means you don't need to login or enter a password, and you will
> automatically get to enable mode. Also the session will timeout after 120
> minutes of idle time.
>
> Regards,
>
> Justin Menga MCSE+I CCNP CCSE ASE
> WAN Specialist
> Computerland New Zealand
> PO Box 3631, Auckland
> DDI: (+64) 9 360 4864 Mobile: (+64) 25 349 599
> mailto: justin.menga@computerland.co.nz
>
>
> -----Original Message-----
> From: Jack Heney [mailto:jheneyccie@hotmail.com]
> Sent: Friday, 13 October 2000 8:03 a.m.
> To: ccielab@groupstudy.com
> Subject: Enabling Remotely
>
>
> Kind of a silly question....Is there a way to allow telnet access without
> requiring any passwords (either line or enable)? Having to enable and enter
>
> a password every time I jump from router to router from my terminal server
> has started to get under my skin (I think this is an indication that I spend
>
> too much time in my lab). I'm at the point where I'm configuring my routers
>
> with one-letter enable passwords, but I typing that one extra character
> (plus the extra carriage return) every time will be enough to push my
> ever-worsening carpal tunnel syndrome to the near-fatal level. Thanks,
> Jack
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:26 GMT-3