From: Clifton Stewart (cliftonlstewart@xxxxxxxx)
Date: Mon Oct 09 2000 - 18:36:30 GMT-3
John,
Did you enter ip pim nbma-mode on the hub, also ensure that the command
ip pim sparse-mode -or- ip pim dense-mode is enable on each
participating interface.
Have you had any success with AppleTalk running over ASYNC? So far I've
tried using the client-mode command on each side. Enabled a appletalk
virtual-net with no success. Removed the configs and attemped to use an
cable-range and a zone like any other interface with no success. If I
put ip addresses on the point2point link and enable EIGRP I am able to
ping across the ASYNC. So I know my cable is good. Any suggestions?
-Cliff
> John Conzone wrote:
>
> This has been covered before, but I have not seen a working
> solution to this problem. There are a few posts in the archives
> regarding trying the nbma command (doesn't help), but it seems that
> there is an isssue (s) with running PIM over a frame cloud.
> I am having the same difficulties as some.
> Does anyone have a definitive answer to the problem of spokes
> unable to ping other spokes thru a hub using multicast addressses and
> PIM sparse or dense.
> Works fine on ethernet and regular serial.
> Thanks!
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:24 GMT-3