ISL on a 2900XL with SA6 Enterprise code

From: Roy Grego (ccsi100@xxxxxxxxx)
Date: Mon Oct 09 2000 - 03:27:43 GMT-3

• Next message: damien: "Reposted !! Defaults from OSPF into BGP"
• Previous message: Dave Humphrey: "RE: OT: Juniper........"
• Next in thread: Arthur Davis: "Re: ISL on a 2900XL with SA6 Enterprise code"
• Maybe reply: Arthur Davis: "Re: ISL on a 2900XL with SA6 Enterprise code"
• Maybe reply: Jay Hennigan: "Re: ISL on a 2900XL with SA6 Enterprise code"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi Guys,

I am still having trouble getting my switch to route
between vlans. I have a 2900XL with Enterprise code &
SA6 IOS.

My switch config is:
interface FastEthernet0/1
 switchport mode multi
 switchport multi vlan add 20 30

(There is no switchport mode trunk command available)

Router Config is:
Interface FastEthernet 0/0
  no ip address
  full-duplex

Interface FastEthernet 0/0.20
   encapsulation isl 20
   ip add 10.1.20.1 255.255.255.0

Interface FastEthernet 0/0.30
   encapsulation isl 30
   ip add 10.1.30.1 255.255.255.0

router ospf 1
  network 10.1.20.1 0.0.0.0 area 0
  network 10.1.30.1 0.0.0.0 area 0

When I ping between I get encap failed messages.

I have also tried IRB with bridge groups on the
sub-interfaces & BVI's.

Thanks,
ROY

• Next message: damien: "Reposted !! Defaults from OSPF into BGP"
• Previous message: Dave Humphrey: "RE: OT: Juniper........"
• Next in thread: Arthur Davis: "Re: ISL on a 2900XL with SA6 Enterprise code"
• Maybe reply: Arthur Davis: "Re: ISL on a 2900XL with SA6 Enterprise code"
• Maybe reply: Jay Hennigan: "Re: ISL on a 2900XL with SA6 Enterprise code"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:24 GMT-3