From: Brian Hescock (bhescock@xxxxxxxxx)
Date: Sat Oct 07 2000 - 15:38:48 GMT-3
Actually, you can. Check the archives, there's been a couple of
discussions on this within the past few months. I know from personal
experience you can do it when using a unix box and dialing into a terminal
server. I believe the break sequence is <ctrl><shift>right
bracket, which is the ] key. You're then given a prompt and you type "send
break" and press enter. Voila, you've done it.
Brian
On Sat, 7 Oct 2000, Wu,Jiang wrote:
> I think you can only reload in privilege mode or configured that command to b
e used in user mode. So you cannot recover a lost password through dial-in.
> For the break key, check:
> http://www.cisco.com/warp/public/701/61.html
>
> ----- Original Message -----
> From: Andy Singh <asingh@slamdunknetworks.com>
> To: <ccielab@groupstudy.com>
> Sent: Friday, October 06, 2000 2:48 AM
> Subject: How to break the password Thru dial-in
>
>
> > I know there a was similar thread a while back but this is lil different
> >
> > I need to recover the password on 3662 via a terminal server. basically the
> > setup is something like this
> >
> > PC (Hyper-term)-----dial-in
> > PSTN-------2611(term-server)---console-async(3662). so I dial in to the
> > terminal server..then console into the 3662 and reload...then I can't send
a
> > break to it for it go into bootprom..is there any other dial in program out
> > there that I can use. any help be appreciate.
> > thanks
> > Andy
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:24 GMT-3