From: kaushik (kaushik@xxxxxxxxx)
Date: Sat Oct 07 2000 - 08:15:09 GMT-3
the command is also a 'macro'.
thus once the command (set port host) is executed, you will not see it
anywhere in your config. You will see its individual components (portfast
on, trunk off, pagp off). Thus should you need to copy from one switch to
another - the word is be careful!
my 2cents
thanks
kaushik
-----Original Message-----
From: Asbjorn Hojmark [SMTP:Asbjorn@Hojmark.ORG]
Sent: Tuesday, October 03, 2000 3:04 PM
To: 'John Koehl'
Cc: ccielab@groupstudy.com
Subject: RE: catalyst 2900 XL ipx appletalk ....vs Cat5K
> There is also a new command in the newer IOS. Set port X/X
> host. It turns off spanning tree and trunk negotiation all
> at once. Much easier.
Good point.
Actually, 'set port host' is a macro that sets portfast (it
doesn't turn of spanning tree), and turns off trunking and
channeling. It's true that it's easier but I think it's vital
to know excatly what it does.
-A
-- Heroes: Vint Cerf & Bob Kahn, Leonard Kleinrock, Robert Metcalfe Links : http://www.hojmark.org/networking/
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:24 GMT-3