Multicast over Frame Relay with spoke as RP

From: Muthu (muthumon@xxxxxxx)
Date: Fri Oct 06 2000 - 22:53:34 GMT-3

• Next message: Dayong Gan: "Lab swap"
• Previous message: Marcello Colaruotolo: "DLSW Source Route Ring #"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi Group,
I was trying to configure Multicasting over frame relay with
Hub and spoke topology. I could able to ping the Multicast address at spoke 1
( 225.1.1.1 ) from the spoke-2 router when HUB IS configured AS rp. So
everything is fine.

My requirement is one of the spoke should be RP. I could not ping multicast
address of Spoke-1 from spoke-2 when spoke-1 is configured as RP.

I am using ip pim sparse mode and ip pim nbma mode at all the frame relay
interfaces and static rp address is configured at hub and spoke-2.

This is the version of the routers IOS,
Spoke-1 is 11.2,
Hub and spoke-2 is 12.1.
Is version mismatch is the problem ???.
Did anybody come across similar problem.
I would appreciate if anyone can send working configuration.

Thanks in advance

Muthu

• Next message: Dayong Gan: "Lab swap"
• Previous message: Marcello Colaruotolo: "DLSW Source Route Ring #"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:24 GMT-3